SSH into UniFi APs, switches and gateways — the part the controller hides.
UniFi devices from the shell rather than the controller: adoption state and provisioning, radio and client diagnostics on an AP, switch port and PoE control, and gateway routing and firewall state.
Installed with SmartCom Revisited 1.6.1 — there is nothing to download. Open the button panel and it is there.
Each one imports on its own, so a bundle this size never arrives as a single wall of buttons. Hide the sets you do not need, or name the ones a connection uses and the panel shows only those.
They arrive pre-tagged, so you do not have to name them at all:
tag
a connection access-point
and the matching sets appear on it.
Adoption state, provisioning, firmware and controller link.
What the controller will not tell you when a device is stuck: adoption and inform state, provisioning status, firmware version, and the guarded set-inform and factory-reset that recover it.
Appears on hosts tagged access-point gateway switch ubiquiti unifi wireless
Radios, SSIDs, associated clients, signal and airtime.
Access point diagnostics: radio channel and power, configured SSIDs, the client table with signal and rates, and per-client history for the "wifi is slow" call.
Appears on hosts tagged access-point gateway switch ubiquiti unifi wireless
Switch ports, PoE, VLANs, gateway routing and firewall.
UniFi switch and gateway side: port state and PoE control including a guarded power cycle, VLAN and bridge membership, and the gateway routing, NAT and firewall tables.
Appears on hosts tagged access-point gateway switch ubiquiti unifi wireless
These commands were written from Ubiquiti's documented syntax and checked for structure — not run against live Ubiquiti UniFi hardware. Every button shows its full script in the app before you press it. For anything destructive, read that script and try it in a lab first.